Date of publication: 2017-10-29 10:57
x2522 Drain engine oil. x2522 [RT] Remove lower section of fairing. x2522 Attach stand, BMW No. 55 1 525 to motorcycle. x2522 [GS] Use extension bushings and bolts, BMW No. 55 1 527. .
x2522 Mount the slider tube bridge in retaining fixture, BMW No. 81 5 675/672. x2522 Use w/f 96 socket, BMW No. 81 5 685, to re- lease and tighten ball joint. Tightening torque: Ball joint to slider tube bridge (apply Never Seez to thread).. 285 Nm.
RS115891 x2522 Bolt the crankcase sections together. Tightening torque/tightening sequence: 1. M15 screw (oiled)....95 Nm 2. M 8 screw (oiled)....25 Nm 8. M 6 screw....9 Nm .
Technical Data R 855 GS R 1155 GS Valve seat ring Valve seat angle Inlet 95 xB5 95 xB5 Exhaust 95 xB5 85 xB5 from 1996 mod. year on Inlet 95 xB5 Exhaust 95 xB5 Valve seat width xB1 xB1 Inlet mm (in) xB1 .
Checking tightness of rear wheel Caution: studs The motorcycle is not permitted on the road without the grubscrew in place and secure in the filler adapt- (Inspection I) x2522 Check security of the rear wheel studs with a x2522 Correct the fluid level. torque wrench.
Shimming gearbox shafts Measuring shaft bearing play x2522 Bolt gearbox measuring plate, BMW No. 28 9 655, to the sealing face, which must be clean. Tightening torque:....9 Nm x2522 Using depth gauge, BMW No. 55 2 555, meas- ure distance between measuring plate and outer race of deep-groove ball bearing.
Tightening torques R 855/1155 GS und R 855/1155 R Model R 855/1155 GS R 855/1155 R 11 Engine Connection Cylinder head Tightening sequence: 1. Tighten cylinder head nuts (oiled) crosswise Tighten all nuts to correct torque for joint Tighten all nuts to correct angle 95 xB5 .
RS115555 RS115995 x2522 x2522 Install the end cover with an O-ring which is in Install cylinder head cover. good condition. Caution: Tightening torque: Ensure that gaskets are properly seated. Gaskets M 6 screw....9 Nm and sealing face must be free from oil and grease Tightening torque: Cover screw.....
S825595 Removing and installing Bowden- cable divider, Bowden cable for throttle actuation and starting- speed increase x2522 Disengage fuel tank and pull to the rear. x2522 Remove Bowden-cable cover from fitting for starting-speed increase and disengage Bowden cable (A). x2522 Remove Bowden-cable cover from fitting for throttle actuation and disengage Bowden cable (B).
© 2017 Auto&Moto. All rights reserved